CCNA 3 Commands List

CCNA3 Commands List Here is the detailed list of CCNA3 commands: Spanning-Tree The default port costs are defined by the speed at which the port operates (ex: 100Mbps have a port cost of 19). To configure the port cost of an interface: SW1(config-if)# spanning-tree cost value value can be between 1 and 200,000,000. The port […]
Continue reading…

 

CCNA 3 v6 Chapter 6 Exam Answers 2017 (100%)

CCNA 3 v5.03 Chapter 6 Exam Answers 2017 (100%)   What is one advantage of using multiarea OSPF? It allows OSPFv2 and OSPFv3 to be running together. It enables multiple routing protocols to be running in a large network. It increases the routing performance by dividing the neighbor table into separate smaller ones. It improves […]
Continue reading…

 

CCNA 3 v6 Chapter 5 Exam Answers 2017 (100%)

¬†CCNA 3 v5.03 Chapter 5 Exam Answers 2017 (100%) What is a recommended method of authentication for OSPFv3? MD5 authentication IPsec to secure routing updates the passive-interface command a VPN tunnel between each OSPF neighbor adjacency A network engineer is troubleshooting convergence and adjacency issues in an OSPFv2 network and has noted that some expected […]
Continue reading…

 

CCNA 3 Chapter 3 v6 Exam Answers 2017 (100%)

The trunk link between two 2960 switches has reached its capacity. How can this be addressed in the most economical way? Increase the speed of the ports. Decrease the size of the inter-switch collision domain by configuring additional VLANs. Combine physical ports into a high-speed logical link by configuring EtherChannel. Create additional broadcast domains by […]
Continue reading…

 

CCNA 3 Chapter 1 v6 Exam Answers 2017 (100%)

Which statement describes a characteristic of Cisco Meraki switches? They promote infrastructure scalability, operational continuity, and transport flexibility. They are cloud-managed access switches that enable virtual stacking of switches. They are campus LAN switches that perform the same functions as Cisco 2960 switches. They are service provider switches that aggregate traffic at the edge of […]
Continue reading…

 

CCNA 3 Chapter 7 v5.02 Exam Answers

CCNA 3 v5.02 Chapter 7 Exam Answers Which protocol is used by EIGRP to send hello packets? TCP UDP RTP IP When an EIGRP-enabled router uses a password to accept routes from other EIGRP-enabled routers, which mechanism is used? bounded updates partial updates EIGRP authentication Diffusing Update Algorithm Reliable Transport Protocol What is the purpose […]
Continue reading…